Configure Rmon Collection History; Enable An Rmon Mib Collection History Group - Dell Force10 S4810P Configuration Manual

Configure RMON collection history

To enable the RMON MIB history group of statistics collection on an interface, use the
command in interface configuration mode. To remove a specified RMON history group of statistics
history
collection, use the
Command Syntax
[no] rmon collection history
{controlEntry integer} [owner
ownername] [buckets bucket-number]
[interval seconds]

Enable an RMON MIB collection history group

The following command enables an RMON MIB collection history group of statistics with an ID number
of 20 and an owner of "john", both the sampling interval and the number of buckets use their respective
defaults.
Figure 41-4. rmon collection history Command Example
FTOS(conf-if-mgmt)#rmon collection history controlEntry 20 owner john
864
| Remote Monitoring (RMON)
form of this command.
no
Command Mode
CONFIGURATION
INTERFACE
(config-if)
Purpose
controlEntry: Specifies the RMON group of
statistics using a value.
integer: A value from 1 to 65,535 that identifies the
RMON group of statistics. The value must be a
unique index in the RMON History Table.
owner: (Optional) Specifies the name of the owner
of the RMON group of statistics.Default is a
null-terminated string.
ownername: (Optional) Records the name of the
owner of the RMON group of statistics.
buckets: (Optional) Specifies the maximum number
of buckets desired for the RMON collection history
group of statistics.
bucket-number: (Optional) A value associated with
the number of buckets specified for the RMON
collection history group of statistics. The value is
limited to from 1 to 1000. Default is 50 (as defined in
RFC-2819).
interval: (Optional) Specifies the number of seconds
in each polling cycle.
seconds: (Optional) The number of seconds in each
polling cycle. The value is ranged from 5 to 3,600
(Seconds). Default is 1,800 as defined in RFC-2819.
rmon collection