Dell Force10 S4810P Configuration Manual page 898

SCP is a remote file copy program that works with SSH and is supported by FTOS.
Note: The Windows-based WinSCP client software is not supported for secure copying between a PC
and an FTOS-based system. Unix-based SCP client software is supported.
To use the SSH client, use the following command in the EXEC Privilege mode:
Command Syntax
{ } [
ssh
hostname
|
-v
port-number
To enable the SSH server for version 1 and 2, use the following command in the CONFIGURATION
mode:
Command Syntax
{
ip ssh server enable | port
To enable the SSH server for version 1 or 2 only, use the following command:
Command Syntax
ip ssh server version
To view the SSH configuration, use the following command in EXEC Privilege mode:
Command Syntax
show ip ssh
Figure 43-6
command to confirm the setting.
ssh
898
| Security
Command Mode
|
EXEC Privilege
-l -p
username
{ | }
1 2
port-number}
Command Mode
{ } CONFIGURATION
1|2
shows the use of the command
Purpose
Open an SSH connection specifying the hostname,
username, port number, and version of the SSH client.
is the IP address or hostname of the remote
hostname
device.
• Enter an IPv4 or IPv6 address in dotted decimal
format (A.B.C.D).
Command Mode Purpose
CONFIGURATION Configure the Dell Force10 system as an
SCP/SSH server.
Purpose
Configure the Dell Force10 system as an SSH server that
uses only version 1 or 2.
Command Mode Purpose
EXEC Privilege Display SSH connection information.
ip ssh server version 2
to enable SSH version 2, and the
show ip