Dell Force10 S4810P Configuration Manual page 849

Figure 40-3. show ip protocols Command Example
FTOS#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is
Default version control: receive version 2, send version 2
Interface
GigabitEthernet 0/0
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway
Distance: (default is 120)
FTOS#
To configure the interfaces to send or receive different RIP versions from the RIP version configured
globally, use either of the following commands in the INTERFACE mode:
Command Syntax
ip rip receive version [ 1 ] [ 2 ]
ip rip send version [ 1 ] [ 2 ]
To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax.
Figure 40-4 displays the command syntax for sending both RIPv1 and RIPv2 and receiving only RIPv2.
Figure 40-4. Configuring an interface to send both versions of RIP
FTOS(conf-if)#ip rip send version 1 2
FTOS(conf-if)#ip rip receive version 2
The
show ip protocols
interface. This interface no longer sends and receives the same RIP versions as FTOS does globally.
1
Recv Send
2 2
Distance Last Update
Command Mode
INTERFACE
INTERFACE
command example Figure 40-5
RIPv2 configured
globally and on the
interface.
Purpose
Set the RIP version(s) received on that interface.
Set the RIP version(s) sent out on that interface.
confirms that both versions are sent out that
Routing Information Protocol (RIP) | 849