Recover From A Card Mismatch State On An S-Series Stack - Dell Force10 S4810P Configuration Manual

High-density, 1ru 48-port 10gbe switch

Hide thumbs Also See for Force10 S4810P:

Table of Contents

--------------------------------------------------------------------------------

Speed in RPM

Recover from a Card Mismatch State on an S-Series Stack

A card mismatch occurs if the stack has a provision for the lowest available stack number which does not

match the model of a newly added unit. See the following example. To recover, disconnect the new unit.

Then, either:

remove the provision from the stack, then reconnect the standalone unit, or

renumber the standalone unit with another available stack number on the stack.

Figure 47-14. Recovering from a Card Mismatch State on an S-Series Stack (S50N and S25N)

-----------------------------------STANDALONE UNIT BEFORE------------------------------------

Standalone#show system brief

Stack MAC : 00:01:e8:d5:ef:81

---------------------------------------------------------------------------

---------------------------------------STACK BEFORE------------------------------------------

Stack#show system brief

Stack MAC : 00:01:e8:d5:f9:6f

---------------------------------------------------------------------------

-----------------------------------STANDALONE UNIT AFTER------------------------------------

01:38:34: %STKUNIT0-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit is present

01:38:34: %STKUNIT0-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 1 present

Going for reboot. Reason is Stack merge

Stacking | 999