Configure Management Interfaces On The S-Series - Dell Force10 S4810P Configuration Manual

• Once the virtual IP address is removed, the system is accessible through the native IP address of the
primary RPM's management interface.
• Primary and secondary management interface IP and virtual IP must be in the same subnet.

Configure Management Interfaces on the S-Series

The user can manage the S-Series from any port. Configure an IP address for the port using the
command, and enable it using the command
INTERFACE mode to note that the interface is the management interface. There is no separate
management routing table, so the user must configure all routes in the IP routing table (the
command).
As shown in the following example, from EXEC Privilege mode, display the configuration for a given port
by entering the command
FTOS#show int gig 0/48
GigabitEthernet 0/48 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
FTOS#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination
-----------
*S 0.0.0.0/0
C 10.11.130.0/23
FTOS#
480
| Interfaces
no shutdown
, and the routing table with the
show interface
Gateway
-------
via 10.11.131.254, Gi 0/48
Direct, Gi 0/48
. The user may use the command
show ip route
Dist/Metric Last Change
----------- -----------
1/0
0/0
ip address
from
description
ip route
command.
1d2h
1d2h