Figure 30-13. Configuring LLDPDU Transmit and Receive Mode
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#mode ?
rx
tx
R1(conf-lldp)#mode tx
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
mode tx
no disable
R1(conf-lldp)#no mode
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#
Configuring Transmit and Receive Mode
Once LLDP is enabled, Dell Force10 systems transmit
configure the system—at CONFIGURATION level or INTERFACE level—to transmit only by executing
the command
no mode
656
|
Link Layer Discovery Protocol (LLDP)
Rx only
Tx only
, or receive only by executing the command
mode tx
command
(Figure
30-14).
receive LLDPDUs by default. You can
and
. Return to the default with the
mode rx