Enable Passive Interfaces - Dell Force10 S4810P Configuration Manual

Enable passive interfaces

A passive interface is one that does not send or receive routing information. Enabling passive interface
suppresses routing updates on an interface. Although the passive interface will neither send nor receive
routing updates, the network on that interface will still be included in OSPF updates sent via other
interfaces.
Use the following command in the ROUTER OSPF mode to suppress the interface's participation on an
OSPF interface. This command stops the router from sending updates on that interface.
Command Syntax
passive-interface {default |
interface}
To enable both receiving and sending routing updates, enter the
When you configure a passive interface, the
"passive interface" to indicate that hello packets are not transmitted on that interface.
Command Mode Usage
CONFIG-ROUTER- Specify whether all or some of the interfaces will be passive.
OSPF-id
Default
the OSPF process.
Entering the physical interface type, slot, and number enable
passive interface on only the identified interface.
•
•
•
•
•
The default keyword sets all interfaces on this OSPF process as passive. The passive
interface can be removed from select interfaces using the
command while
interface
show ip ospf process-id interface
enabled passive interfaces on ALL interfaces in
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information
(
e.g., passive-interface gi 2/1
For a port channel, enter the keyword port-channel
followed by a number from 1 to 255 for TeraScale and
ExaScale.
For a SONET interface, enter the keyword sonet
followed by the slot/port information (
passive-interface so 2/2
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information (e
.g. passive-interface ten 2/3
For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094 (
e.g., passive-interface
.
vlan 2222)
E-Series ExaScale platforms support 4094 VLANs with
FTOS version 8.2.1.0 and later. Earlier ExaScale
supports 2094 VLANS.
passive interface default
no passive-interface interface
Open Shortest Path First (OSPFv2 and OSPFv3) | 743
).
e.g.,
).
).
no passive-interface
is configured.
command.
command adds the words