Configuring Multicast Source Discovery Protocol
Configuring MSDP is a three-step process:
1. Enable an exterior gateway protocol (EGP) with at least two routing domains.
Figure 31-5
in this chapter for MSDP. Otherwise, see
Chapter 9, Border Gateway
2. Configure PIM-SM within each EGP routing domain.
Figure 31-5
MSDP. Otherwise, see
3. Enable MSDP. See page 672.
4. Peer the RPs in each routing domain with each other. See
Related Configuration Tasks
•
Enable MSDP
•
Manage the Source-active Cache
•
Accept Source-active Messages that fail the RFP Check
•
Limit the Source-active Messages from a Peer
•
Prevent MSDP from Caching a Local Source
•
Prevent MSDP from Caching a Remote Source
•
Prevent MSDP from Advertising a Local Source
•
Terminate a Peership
•
Clear Peer Statistics
•
Clear Peer Statistics
•
Debug MSDP
•
MSDP with Anycast RP
•
MSDP Sample Configurations
and
MSDP Sample Configurations on page 688
Protocol.
and
MSDP Sample Configurations
Chapter 35, "PIM Sparse-Mode (PIM-SM)," on page
show the OSPF-BGP configuration used
Chapter 34, Open Shortest Path First (OSPFv2)
show the PIM-SM configuration in this chapter for
Enable
MSDP.
Multicast Source Discovery Protocol (MSDP) | 667
and
777.