Configure Diagnostics - Extreme Networks ExtremeWare Command Reference Manual

configure diagnostics

configure diagnostics [extended | fastpost | normal | off | verbose |
quiet]
Description
Runs switch diagnostics at boot-up.
NOTE
This command is available only on the BlackDiamond 6804 and BlackDiamond 6808 switches.
Syntax Description
extended Selects an extended diagnostic routine to run at boot-up. Takes the switch fabric and ports offline,
and performs extensive ASIC, ASIC-memory, packet switch, and packet loopback tests. This
parameter is not supported in ExtremeWare 6.1.9 or 6.2.
fastpost Selects fastpost diagnostic routine to run at boot-up. Takes the switch fabric offline and performs a
simple ASIC test.
normal Selects normal diagnostic routine to run at boot-up. Takes the switch fabric and ports offline, and
performs a simple ASIC and packet loopback test on all the ports. This parameter is not supported in
ExtremeWare 6.1.9 or 6.2.
off Stops boot-up diagnostics.
verbose Specifies that the results of every test are recorded in the log. The verbose option is not saved
through a reboot, so you must reconfigure verbose mode after running diagnostics.
quiet Specifies that only the pass or fail result is recorded in the log.
Default
Fastpost, quiet.
Usage Guidelines
To run diagnostics on an I/O module, use the following command:
run diagnostics [ cable | extended | normal packet-memory] slot [<slot> | msm-a |
msm-b | msm-c | msm-d]
The ,
cable extended
To view results of the diagnostics test, use the following command:
show diagnostics
Example
The following command configures the MSM to run the fastest diagnostics at boot-up:
configure diagnostics fastpost
ExtremeWare 7.7 Command Reference Guide
, and modes are not supported on bootup at this time.
normal
configure diagnostics
1239