Unconfigure Switch - Extreme Networks ExtremeWare Command Reference Manual

unconfigure switch

On the "i" series switches:
unconfigure switch {all} {enhanced}
On the "e" series switches:
unconfigure switch {all}
Description
Returns the switch configuration to its factory default settings.
Syntax Description
all
enhanced
Default
Resets configuration to factory defaults without reboot.
Usage Guidelines
Use the
unconfigure switch
erasing the configuration and rebooting. This preserves user account information such as date and time
settings.
Include the parameter
reboot using the last used image and configuration.
On the "i" series switches, include the parameter
with the exception of the default configuration mode, which will be set to enhanced. In enhanced mode,
the switch boots with all ports disabled. If the
configuration mode will be reset to the standard mode, in which the switch boots with all ports in
forwarding mode. To configure the default startup configuration for the switch, use the
configuration-mode
NOTE
After using the
VLAN default without any ports assigned. The ports still belong to the VLAN default, as the show vlan
output correctly displays.
Example
The following command erases the entire current configuration, resets to factory defaults, and reboots
the switch using the last specified saved image and saved configuration:
unconfigure switch all
ExtremeWare 7.7 Command Reference Guide
Specifies that the entire current configuration should be erased, and the switch rebooted.
Specifies that the entire current configuration should be erased with the exception of the default
configuration mode, which will be set to enhanced. In enhanced mode, the switch boots with all
ports disabled.
NOTE: This option applies only to the "i" series switches.
command to reset the configuration to factory defaults, but without
to clear the entire current configuration, including all switch parameters, and
all
command.
unconfigure switch all
to clear the entire current configuration,
enhanced
parameter is not entered, the default
enhanced
command, the
show configuration
unconfigure switch
configure
output displays the
1155