Download Configuration - Extreme Networks ExtremeWare Command Reference Manual

download configuration

download configuration [<ip address> | <hostname>] <filename> {incremental}
Description
Downloads a previously saved ASCII configuration file from a specific TFTP server host.
Syntax Description
ip address
hostname
filename
incremental
Default
N/A
Usage Guidelines
Unless you specify the
current switch configuration and replacing it with the new downloaded configuration. You will be
prompted to reboot the switch after the download is complete. If you do not reboot when prompted, the
switch views the configuration file as corrupted and the next time you reboot the switch prompts you to
reset to the factory defaults.
The new configuration information is stored in switch run-time memory, and is not retained if the
switch has a power failure. After the switch has rebooted, you should save the configuration to the
primary or secondary configuration area to retain it through a power cycle. You can include a
command at the end of the configuration file to have the save done at the end of the download.
The file on the server is assumed to be located relative to the TFTP server base directory. You can
specify a path as part of the file name.
Use of the
hostname
Use the
incremental
the commands specified in the incremental download file are executed, but configuration settings not
specified in the file are left intact. No reboot is required.
Examples
The following command clears the current switch configuration, and downloads a new full
configuration from the TFTP server called tftphost. It uses the configuration from the file stdconfigs.txt
residing in the subdirectory configs\archive of the TFTP server base directory on the server:
download configuration tftphost configs\archive\stdconfig.txt
The following command downloads a partial configuration from the TFTP server called tftphost from
the file modifyconfig.txt (residing in the subdirectory configs\archive on the server):
download configuration tftphost configs\archive\modifyconfig.txt incremental
ExtremeWare 7.7 Command Reference Guide
Specifies the IP address of the TFTP server from which the configuration should be obtained.
Specifies the hostname of the TFTP server from which the configuration should be obtained.
Specifies the path and filename of a saved ASCII configuration.
Specifies an incremental configuration download (v 6.0 or later).
keyword, this command does a complete download, resetting the
incremental
parameter requires that DNS be enabled.
keyword to specify an incremental or partial configuration download. In this case,
download configuration
save
1141