Configure Debug-Trace Card-State-Change - Extreme Networks ExtremeWare Command Reference Manual
Version 7.7
Hide thumbs
Also See for ExtremeWare:
- Command reference manual (2546 pages) ,
- Command reference manual (2254 pages) ,
- Command reference manual (1598 pages)
Table of Contents
Advertisement
Troubleshooting Commands
configure debug-trace card-state-change
configure debug-trace card-state-change <debug level>
Description
This command is not currently supported.
Syntax Description
debug level
Specifies a debug level:
0 — Not currently supported.
1 — Not currently supported.
2 — Not currently supported.
3 — Not currently supported.
4 — Not currently supported.
5 — Not currently supported.
Default
The default level is 0.
Usage Guidelines
This command is not currently supported.
Example
This command is not currently supported.
History
This command was first available in ExtremeWare 6.1.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
1170
ExtremeWare 7.7 Command Reference Guide
Advertisement
Table of Contents
