Show Configuration - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Configuration and Image Commands

show configuration

show configuration [detail]

Displays the currently active configuration to the terminal.

Syntax Description

Specifies to show all configuration statements including default commands.

Usage Guidelines

If the output scrolls off the top of the screen, you can use the

command to pause

enable clipaging

the display when the output fills the screen. The default for clipaging is enabled.

After you use the unconfigure switch all command, the show configuration output displays the VLAN

default without any ports assigned. The ports still belong to the VLAN default, as the show vlan output

correctly displays.

This command shows the current configuration active in the switch:

show configuration detail

This command was available in ExtremeWare 2.0.

This command was modified to show the auto-negotiation status of Gigabit Ethernet ports in

ExtremeWare 6.2.2.

This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.

The command was modified in ExtremeWare 7.2e to support the

Platform Availability

This command is available on all platforms.

ExtremeWare 7.7 Command Reference Guide

Extremeware 7.7