Enable Netlogin - Extreme Networks ExtremeWare Command Reference Manual

enable netlogin

enable netlogin [web-based | dot1x |mac]
Description
Enables network login authentication modes.
Syntax Description
web-based
dot1x
mac
Default
Web-based and 802.1x authentication are enabled by default.
MAC-based authentication is disabled by default.
Usage Guidelines
All types, any combination of types, or no type of authentication can be enabled on the same switch. To
disable an authentication mode, use the following command:
disable netlogin [web-based |dot1x |mac]
This command was first introduced as
login, the web-based mode. The original command was subsequently deprecated when the 802.1x mode
of network login was introduced in ExtremeWare 7.1.0. The deprecated version of the command is
temporarily supported in configurations. During an upgrade, the deprecated command
will be interpreted as:
enable netlogin web-based
enable netlogin dot1x
Example
The following command enables web-based network login:
enable netlogin web-based
The following command globally enables MAC-based network login:
enable netlogin mac
History
This command was first available in ExtremeWare 7.0.0.
The
web-based
command (without the new keywords) was deprecated.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
ExtremeWare 7.7 Command Reference Guide
Specifies web-based authentication.
Specifies 802.1x authentication.
Specifies MAC-based RADIUS authentication.
enable netlogin
and keywords were added in ExtremeWare 7.1.0, and the initial version of the
dot1x
, which enabled the initial version of network
enable netlogin
enable netlogin
1031