Configure Debug-Trace Slb-Failover - Extreme Networks ExtremeWare Command Reference Manual

Troubleshooting Commands

configure debug-trace slb-failover

configure debug-trace slb-failover <debug level>
Description
This command records debug information to the syslog.
NOTE
This command is available only on the "i" series switches.
Syntax Description
debug level Specifies a debug level:
0 — Records possible software errors such as unexpected function call failures and bad function
arguments.
1 — Records configuration errors, insufficient memory, and bad data from a peer SLB switch.
2 — Records when a peer SLB switch has come up or gone down.
3 — Displays debug messages.
4 — No additional information recorded.
5 — No additional information recorded.
Default
The default level is 0.
Usage Guidelines
The range is 0 to 5. Higher levels record more verbose messages. Higher levels also
debug level
record the messages recorded at lower levels.
Example
The following command sets the reporting level for SLB failover errors to 3:
configure debug-trace slb-failover 3
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on"i" platforms only.
1228 ExtremeWare 7.7 Command Reference Guide