Extreme Networks ExtremeWare Command Reference Manual page 1259

Example
The following command runs a packet-memory scan on the board in slot 4 on a BlackDiamond:
run diagnostics packet-memory slot 4
The command initially generates the following messages:
Running packet memory diagnostics will disrupt network traffic on the system.
WARNING: Device may be taken offline. To prevent this
first configure "sys-health-check auto-recovery online"
Are you sure you want to continue?
If you respond with "y" the scan proceeds.
If you run the packet-memory test on a slot that has no packet memory errors, the output from the
command will be similar to the following:
* BD3>:17 # Starts scanning packet memory on card 4.
<diagPM-1> INFO: entering packet memory scanning for card 4
................|................|................
Finished scanning packet memory for card 4 --
>>> No new defect <<<
If packet memory errors are detected, output similar to the following is displayed:
* BD3>:23 # Starts scanning packet memory on card 2.
<diagPM-1> INFO: entering packet memory scanning for card 2
................|................|.............
Checking Struct...has 0 entries
Received Packet
00 | 34 26 49 80 64 50 14 1f 60 54 1d a3 27 ee 5c 44
10 | 01 fd 1b 2a 15 0c 4e 79 71 c5 3c 19 1e 6b 36 83
20 | 40 39 35 79 67 2e 25 6c 7e ae 01 06 49 10 61 0e
30 | 3d da 55 9d 02 67 40 62 2a 2f 3a 64 47 dc 00 86
Transmit Packet
00 | 34 26 49 80 64 50 14 1f 60 54 1d a3 27 ee 5c 44
10 | 01 fd 1b 2a 15 0c 4e 79 71 c5 3c 19 1e 6b 36 83
20 | 44 39 35 79 67 2e 25 6c 7e ae 01 06 49 10 61 0e
30 | 3d da 55 9d 02 67 40 62 2a 2f 3a 64 47 dc 00 86
MEMID=9, recov=0, bit_position=0
Finished scanning packet memory for card 2 --
>>> New defect(s) detected <<<
History
This command was first available in ExtremeWare 6.1.5.
The command was modified to support the MPLS module in an ExtremeWare IP Technology Services
Release based on ExtremeWare v6.1.8b12.
The command was modified to support MSM modules in ExtremeWare 6.1.9.
The command was modified to support Alpine and Summit switches in ExtremeWare 6.2.
The command was modified to support Packet Memory scanning for Black Diamond I/O modules in
ExtremeWare 6.2.1. See the Release Note for information on which modules are supported.
ExtremeWare 7.7 Command Reference Guide
yes/no
, addr=101290, entry=0...
run diagnostics packet-memory slot
1259