Show Diagnostics Packet-Memory Slot - Extreme Networks ExtremeWare Command Reference Manual

show diagnostics packet-memory slot

show diagnostics packet-memory [msm-a | mem-b | mem-c | msm-d | <slot
number>]
Description
Displays the results of the packet memory scan on BlackDiamond 6808 and BlackDiamond 6816 I/O
modules or MSMs.
NOTE
This command is available only on the BlackDiamond switch.
Syntax Description
msm-a | msm-b |
msm-c | msm-d
slot number
Default
N/A
Usage Guidelines
Use this command to display the results of a packet memory scan. The command output displays the
number of defects identified, and the number that were recoverable. If packet memory defects were
found, it displays information about each defect.
In ExtremeWare 6.2.1, this applies only to the G8Xi, G8Ti, G12SXi, and F48Ti. MSMs are not supported
in this release. In ExtremeWare 6.2.2, this apples to all "i"series modules and switches.
Example
The following command displays the results of a PM scan for slot 2, where a single defect was found:
show diagnostics packet-memory slot 2
If no defects are found, the output will look similar to the following:
------------------------------------------------------
Packet memory defect info for card 1
------------------------------------------------------
Num of defects = 0, num of recoverable defects = 0
------------------------------------------------------
If defects are found, the output displays the number of defects, and provides information about each
identified defect.
------------------------------------------------------
ExtremeWare 7.7 Command Reference Guide
Specifies an MSM.
Specifies the slot number of an I/O module.
show diagnostics packet-memory slot
1273