Configure Debug-Trace Rip-Message - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace rip-message

configure debug-trace rip-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
debug level
vlan name
Default
The default level is 0.
Usage Guidelines
The
debug level
record the messages recorded at lower levels.
Example
The following command sets the reporting level for RIP message errors to 3:
configure debug-trace rip-message 3
Following is the log output at this level:
<DBUG:RIP > Sending Rsp to 224.0.0.9 at 1012569160.950000
<INFO:SYST> msm-a-console admin: configure debug-trace rip-message 3 vlan all
History
This command was first available in ExtremeWare 6.1.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.7 Command Reference Guide
Specifies a debug level:
0 — None.
1 — None.
2 — None.
3 — Records that the switch received a response from w.x.y.z (pier) len 24 at time.time.
Records that the switch sent a response to 224.0.0.9 at time.time.
4 — Displays a dump of the RIP response.
Displays a dump of the RIP response received.
5 — No additional information recorded.
Specifies a VLAN name.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also
configure debug-trace rip-message
1223