Configure Iproute Route-Map - Extreme Networks ExtremeWare Command Reference Manual

IP Unicast Commands

configure iproute route-map

configure iproute route-map [bgp | direct | e-bgp | i-bgp | ospf |
ospf-extern1 | ospf-extern2 | ospf-inter | ospf-intra | rip | static]
[<route map> | none]
Description
Configures the contents of the IP routing table.
Syntax Description
bgp Specifies BGP routing.
direct Specifies direct routing.
e-bgp Specifies E-BGP routing.
i-bgp Specifies I-BGP routing.
opsf Specifies OSPF routing.
ospf-extern1 Specifies OSPF External 1 routing.
ospf-extern2 Specifies OSPF External 2 routing.
ospf-inter Specifies OSPFInter routing.
ospf-intra Specifies OSPFIntra routing.
rip Specifies RIP routing.
static Specifies static routing.
route map Specifies a route map.
none Specifies not to use a route map.
Default
N/A
Usage Guidelines
Route maps for IP routing can be configured based on the route origin. When routes are added to the IP
routing table from various sources, the route map configured for the origin of the route is applied to the
route. After matching on specified characteristics, the characteristics for the route can be modified using
the route maps. The characteristics that can be matched and modified are dependent on the origin of
the route. Route maps for IP routing can be dynamically changed. In the case of direct and static route
origins, the changes are reflected immediately. In the case of routes that are sourced from other origin,
the changes are reflected within 30 seconds.
MPLS uses route map-based filters for controlling label advertisement and label propagation. The
implementation of the
delete route-map <route-map>
MPLS module.
Example
The following command configures the IP routing table bgp_out to BGP routing:
configure iproute route-map bgp_out bgp
1682
command has been augmented to support the
ExtremeWare 7.7 Command Reference Guide