Show Debug-Trace - Extreme Networks ExtremeWare Command Reference Manual

show debug-trace

On the "i" series switches:
show debug-trace [accounting | bootprelay | card-state-change | debug-link|
dvmrp-cache | dvmrp-hello | dvmrp-message | dvmrp-neighbor | dvmrp-route |
dvmrp-timer | e1 | eaps-system | eaps-slave-msm | flow-redirect | flowstats
| health-check | iparp | iproute | ipxgns-messages | ipxrip-message |
ipxrip-route | ipxsap-entry | ipxsap-message | isis-cli | isis-event |
isis-hello | isis-lsp | isis-snp | isis-spf | lcp | mpls | mpls-signaling |
nat | ncp | netlogin | npcard | npdiag | pim-cache | pim-hello |
pim-message | pim-neighbor | pim-rp-mgmt | pppauth | ppphexdump |
rip-message | rip-route-change | rip-triggered-update | slave-msm |
slb-3dns | slb-connection | slb-failover | snmp-trace | stp-in-pdu |
stp-out-pdu | stp-system | t1 | t3 | transceiver-test | udp-forwarding |
vrrp | vrrp-hello | xp | wireless ports [all | <portlist>] <wireless debug
trace>] vlan <vlan name>
On the "e" series switches:
show debug-trace [accounting | bootprelay | debug-link | eaps-system |
iparp | iproute | netlogin | npcard | npdiag | pppauth | ppphexdump |radius
| rip-message | rip-route-change | rip-triggered-update | snmp-trace |
stp-in-pdu | stp-out-pdu | stp-system | vrrp | vrrp-hello | wireless ports
[all | <portlist>] <wireless debug trace>] vlan <vlan name>
Description
Displays the configured debug-trace levels.
Syntax Description
accounting
bootprelay
card-state-change
debug-link
dvmrp-cache
dvmrp-hello
dvmrp-message
dvmrp-neighbor
dvmrp-route
dvmrp-timer
ExtremeWare 7.7 Command Reference Guide
Specifies accounting level.
Specifies BOOTP relay level.
Specifies card state change level.
NOTE: This option is available only on the "i" series switches.
Specifies link detection level.
Specifies DVMRP cache level.
NOTE: This option is available only on the "i" series switches.
Specifies DVMRP hello level.
NOTE: This option is available only on the "i" series switches.
Specifies DVMRP message level.
NOTE: This option is available only on the "i" series switches.
Specifies DVMRP neighbor level.
NOTE: This option is available only on the "i" series switches.
Specifies DVMRP route level.
NOTE: This option is available only on the "i" series switches.
Specifies DVMRP timer level.
NOTE: This option is available only on the "i" series switches.
show debug-trace
1261