Clear Wireless Ports Flash-Image - Extreme Networks ExtremeWare Command Reference Manual

clear wireless ports flash-image

clear wireless ports [all | <portlist>] flash-image
Description
Forces an AP runtime image upgrade using the specified image on the TFTP server.
Syntax Description
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form 1,
2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all ports.
Default
N/A
Usage Guidelines
An Altitude 300 AP usually loads its runtime image from the flash instead of TFTP server if the AP
flash contains the latest runtime image version. This command can be used to force-upgrade one or
more APs with the specified image on the TFTP server without checking the version of the AP image
downloaded from the TFTP server.
Before you use this command, configure the runtime image for the specified wireless ports.
Upon execution of this command, the AP resets and replaces the flash image with the specified image
on the TFTP server.
This command may be useful for support personnel in certain circumstances during troubleshooting.
Example
The following example force-upgrades the runtime image for wireless port 1:1:
clear wireless ports 1 : 1 flash-image
AP(s) for which runtime image is configured will be reset and force-upgraded with the
network image without any version checking.
Are you sure you want to continue(y/n)?y
History
This command was first available in ExtremeWare 7.6.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine
switches.
ExtremeWare 7.7 Command Reference Guide
clear wireless ports flash-image
1293