Show Cpu-Dos-Protect - Extreme Networks ExtremeWare Command Reference Manual

show cpu-dos-protect

For the "i" switches:
show cpu-dos-protect
For the "e" switches:
show cpu-dos-protect [ports <portnumber>]
Description
Displays the status of denial of service protection for the entire switch or for a particular port (on the
"e" series switches).
Syntax Description
There are no arguments or variables for this command in the "i" switches.
On the "e" switches, the syntax is:
portnumber
Default
The output of this command has valid values only when denial of service protection is enabled.
Usage Guidelines
None
Examples
The following command displays the status of denial of service protection on an "i" series switch.
show cpu-dos-protect
Following is the output from this command:
Denial-of-service protection to CPU is ENABLED
Notice level:
Alert level:
Filter types: destination
ACL timeout:
ACL rule precedence: 10
Messages are ON
Trusted Ports:
ACL is active ports 48 to 192.168.3.1 proto all precedence 10
ACL should expire in 13 seconds
The following command displays the status of denial of service protection on port 1.
show cpu-dos-protect ports 1
Following is the output from this command:
ExtremeWare 7.7 Command Reference Guide
Specifies one or more port numbers. May be in the form 1, 2, 3-5.
4000 new packets/second (level for logging)
4000 new packets/second (level for ACL creation)
15 seconds
none
show cpu-dos-protect
1069