Show Rate-Limit - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

show rate-limit

show rate-limit {<name> | ports <portlist>}
Description
Displays information for a specific rate limit rule or for all rate limit rules.
NOTE
This command is available only on the "e" series switches.
Syntax Description
name Specifies the name of a rate limit rule.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a list of slots and ports.
On a stand-alone switch, can be one or more port numbers. May be in the form 1, 2, 3-5, 1:5,
1:6-1:8.
Default
N/A
Usage Guidelines
If you do not specify a rate limit name, information is displayed for all the rate limit rules.
Examples
The following command displays all rate limit information configured for the switch:
#show rate-limit
Output from this command is similar to the following:
Rate-limit Access-mask
r1
r2
Flags: DM=Dest MAC, SM=Source MAC, ET=Ether Type,
T=TOS, C=Code Point, I=IP Protocol
DI=Dest IP, SI=Src IP, D4=Dest L4 Port, S4=Src L4 Port
MT=ICMP Type, MC=ICMP Code, EP=Egress Port
P=Permit, Q=Qosprofile, SC=Set Code-Point, SD=Set Dot.1p
ED=Exceed Drop, EC=Exceed Set Code-Point
The next example shows information for the r1 rate limit:
#show rate-limit r1
Rate-Limit with name "r1" created by user
Access-mask:
MAC:
IP/mask:L4port: dest-ip=13.13.13.0/24:---- source-ip=none/--:----
Layer 2:
Layer 3/4:
1086
Vlan QoS Limit Port Flags
f1
f3
"f1"
10 5 DI-IP-P-EC
3 3 IP-P-ED
ExtremeWare 7.7 Command Reference Guide