show arp
The show arp privileged EXEC command displays entries in the ARP table.
Syntax
show arp
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
To enter an out-of-band IP interface, use the out-of-band IP address format — oob/ip-
address. Only the broadcast-address command is available on out-of-band IP interfaces.
Example
The following example displays entries in the ARP table.
Console# show arp
ARP timeout: 60000 Seconds
Interface
--------------- --------------- ------------------- -------------
Oob-eth 1
Oob-eth 1
directed-broadcast
The directed-broadcast interface configuration command enables the translation of a directed
Broadcast to physical Broadcasts. To disable this function, use the no form of this command.
Syntax
directed-broadcast
no directed-broadcast
Default Configuration
Disabled, all IP directed broadcasts are dropped.
IP address
10.30.2.1
00:00:0c:07:ac:0a
10.30.2.2
00:07:84:a7:ca:bc
HW address
IP Addressing Commands
status
dynamic
dynamic
165