Telnet - Dell PowerConnect 6024F Command Line Interface Reference Manual

The following table describes the characters that can appear in the traceroute user EXEC
command output.
Field
*
?
A
F
H
N
P
Q
R
S
U

telnet

The telnet user EXEC command logs into a host that supports Telnet.
Syntax
telnet {ip-address | hostname} [port] [keyword1......]
• ip-address — Valid IP address of the destination host. For information on specifying an
out-of-band IP address, see the user guidelines.
• hostname — Hostname of the destination host. (Range: 1 - 158 characters)
• port — A decimal TCP port number, or one of the keywords from the ports table in the
user guidelines.
• keyword — One or more keywords from the keywords table in the user guidelines.
Default Configuration
port — Telnet port (decimal 23) on the host.
Command Mode
User EXEC mode
User Guidelines
Telnet software supports special Telnet commands in the form of Telnet sequences that map
generic terminal control functions to operating system-specific functions. To issue a special
Telnet command, press Esc and then a command character.
434
System Management
Description
The probe timed out.
Unknown packet type.
Administratively unreachable. Usually, this output indicates that an access
list is blocking traffic.
Fragmentation is required, and DF is set.
Host unreachable.
Network unreachable.
Protocol unreachable.
Source quench.
Fragement reassembly time exeeded.
Source route failed.
Port unreachable.