Acl Commands; Address Table Commands - Dell PowerConnect 6024F Command Line Interface Reference Manual

ACL Commands

Command Group
ip access-list
permit (IP)
deny (IP)
mac access-list
permit (MAC)
deny (MAC)
service-acl
show access-lists
show interfaces access-lists

Address Table Commands

Command Group
bridge address
bridge multicast filtering
bridge multicast address
bridge multicast forbidden
address
bridge multicast forward-all
28
Command Groups
Description
Creates IP ACLs, and enters to IP-
Access list configuration mode.
Allows traffic if the conditions
defined in the permit statement
are matched.
Denies traffic if the conditions
define in the deny statement are
matched
Creates Layer 2 MAC ACLs, and
enters to MAC-Access list
configuration mode.
Allows traffic if the conditions
defined in the permit statement
are matched.
Allows traffic if the conditions
defined in the permit statement
are matched.
Applies an access-list to the input
of an interface.
Displays access control lists
(ACLs) defined on the switch.
Displays access lists applied on
interfaces.
Description
Adds a static MAC-layer station source address to the bridge table.
Enables filtering of Multicast addresses.
Registers MAC-layer Multicast addresses to the bridge table, and adds
static ports to the group.
Forbids adding a specific Multicast address to specific ports.
Enables forwarding of all Multicast packets on a port.
Mode
GC
IP
IP
GC
MT
MT
IC
PE
PE
Mode
VC
GC
VC
VC
VC