Garp Timer - Dell PowerConnect 6024F Command Line Interface Reference Manual

Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port would not dynamically join a VLAN because it is always a member in only one
VLAN.
Example
The following example enables GVRP on ethernet g8.
Console (config)# interface ethernet g8
Console (config-if)# gvrp enable

garp timer

The garp timer interface configuration command adjusts the GARP application join, leave, and
leaveall GARP timer values. To reset the timer to default values, use the no form of this command.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer
• join—Indicates the time in milliseconds that PDUs are transmitted.
(Range: 10-2147483640)
• leave—Indicates the amount of time in milliseconds that the device waits before leaving
its GARP state. The Leave Time is activated by a Leave All Time message sent/received,
and cancelled by the Join message. (Range: 10-2147483640)
• leaveall—Used to confirm the port within the VLAN. The time in milliseconds between
messages sent. (Range: 10-2147483640)
• timer_value—Timer values in milliseconds.
Default Configuration
The default timer values are as follows:
• Join timer—200 milliseconds
• Leave timer—600 milliseconds
• Leavall timer—10000 milliseconds
Command Mode
Interface configuration (Ethernet, port-channel) mode
152
GVRP Commands