Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245
on port g8 to the bridge table.
Console (config)# interface vlan 2
Console (config-vlan)# bridge address 3aa2.64b3.a245 ethernet g8
permanent
bridge multicast filtering
The bridge multicast filtering global configuration command enables filtering of Multicast
addresses. To disable filtering of Multicast addresses, use the no form of the bridge multicast
filtering command.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Disabled. All Multicast addresses are flooded to all ports of the relevant VLAN.
Command Mode
Global Configuration mode
User Guidelines
If Multicast routers exist on the VLAN and IGMP, snooping is not enabled, the bridge
multicast forward-all command should be used to enable forwarding all Multicast packets to
the Multicast routers.
Example
In this example, bridge Multicast filtering is enabled.
Console (config)# bridge multicast filtering
bridge multicast address
The bridge multicast address interface configuration command registers MAC-layer Multicast
addresses to the bridge table, and adds static ports to the group. To unregister the MAC address,
use the no form of the bridge multicast address command.
Syntax
bridge multicast address {mac-multicast-address | ip-multicast-address}
88
Address Table Commands