Examples
The following example sets the time for the retransmission of an EAP-request frame to the client to
3600 seconds:
Console(config-if)# dot1x timeout supp-timeout 3600
dot1x timeout server-timeout
The dot1x timeout server-timeout interface configuration mode command sets the time that the
device waits for a response from the authentication server before retransmitting packets. To return
to the default setting, use the no form of this command..
Syntax
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
•
seconds — Time in seconds that the device waits for a response from the authentication
server. (Range: 1 - 65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example sets the time for the retransmission of packets to the authentication server.,
to 3600 seconds:
Console(config-if)# dot1x timeout server-timeout 3600
show dot1x
The show dot1x privileged EXEC command displays 802.1x status for the device or for the
specified interface.
Syntax
show dot1x [ethernet interface]
•
interface — Valid Ethernet port.
494
802.1x Commands