Dell PowerConnect 6024F Command Line Interface Reference Manual page 364
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
•
auth-md5 password—Indicates the HMAC-MD5-96 authentication level. The user
should enter a password for authentication and generation of a DES key for privacy.
(Range: 1-32 characters)
•
auth-sha password—Indicates the HMAC-SHA-96 authentication level. The user should
enter a password for authentication and generation of a DES key for privacy. (Range: 1-32
characters)
•
auth-md5-key md5-des-keys—Indicates the HMAC-MD5-96 authentication level. The
user should enter a concatenated hexadecimal string of the MD5 key (MSB) and the
privacy key (LSB). If authentication is only required, 16 bytes should be entered; if
authentication and privacy are required, 32 bytes should be entered. Each byte in the
hexadecimal character string is two hexadecimal digits. Each byte can be separated by a
period or colon. (16 or 32 bytes)
•
auth-sha-key sha-des-keys—Indicates the HMAC-SHA-96 authentication level. The user
should enter a concatenated hexadecimal string of the SHA key (MSB) and the privacy
key (LSB). If authentication is only required, 20 bytes should be entered; if
authentication and privacy are required, 36 bytes should be entered. Each byte in the
hexadecimal character string is two hexadecimal digits. Each byte can be separated by a
period or colon. (20 or 36 bytes)
Default Configuration
No group entry exists.
Command Mode
Global Configuration mode
User Guidelines
If auth-md5 or auth-sha is specified, both authentication and privacy are enabled for the user.
The engine ID is a two-digit hexadecimal string. If a single digit number is specified, the
device interprets it as a two-digit number by adding a 0 before the number. For example,
"1.2.3.3.2.1" is interpreted as "01.02.03.03.02.01.
When a show running-config privileged EXEC command is entered, a line for this user will
not be displayed. To see if this user has been added to the configuration, type the show snmp
users privileged EXEC command.
Examples
The following example configures an SNMPv3 user "John" in group "user-group".
Console (config)# snmp-server user John user-group
364
SNMP Commands
Advertisement
Table of Contents
