The service-policy interface configuration command cannot be used to attach policy maps
that contain set or trust policy-map class configuration commands or that have access control
list (ACL) classification to an egress interface. The only match criterion supported is match
ip dscp dscp-list. For non-IP packets, the final CoS is converted to DSCP for classification
purposes. If there is an attempt to apply a policy map on an egress interface with anything
other than the match ip dscp class-map configuration command, an error message is
generated.
Example
The following example creates policy map called "policy1".
Console (config)# policy-map policy1
Console (config-pmap)#
show policy-map
The show policy-map user EXEC command displays the defined policy maps.
Syntax
show policy-map [policy-map-name [class class-name]]
•
policy-map-name—The policy map name being displayed.
•
class class-name—Displays the QoS policy action for individual classes.
Default Configuration
If a specific policy-map is not requested, all policy-maps are displayed.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
309
QoS Commands