Router Ospf Area Default-Cost - Dell PowerConnect 6024F Command Line Interface Reference Manual

User Guidelines
The router ospf area stub command must be configured on all routers and access servers in
the stub area. Use the area router configuration command with the default-cost option to
specify the default internal router cost sent into a stub area by an ABR.
There are two stub area router configuration commands: the stub and default-cost options of
the area router configuration command. In all routers attached to the stub area, the area
should be configured as a stub area using the area command stub option. Use the default-cost
option only on an ABR attached to the stub area. The default-cost option provides the metric
for the summary default route generated by the ABR into the stub area.
If a question mark is specified at the end of the router ospf area stub command, the same
hint is displayed twice at the prompt line.
Example
The following example defines an OSPF stub area 7.7.7.7.
Console (config)# router ospf area 7.7.7.7 stub

router ospf area default-cost

The router ospf area default-cost global configuration command specifies a cost for the default
summary route sent into a stub area. To remove the assigned default route cost, use the no form of
this command.
Syntax
router ospf area area-id default-cost cost
no router ospf area area-id default-cost
• area-id—Area associated with the OSPF address range. It can be specified as either a
decimal value or as an IP address.
• cost—Cost for the default summary route used for a stub area. (Range: 1 - 16777215)
Default Configuration
A default value is automatically calculated by the router according to RFC 1850.
Command Mode
Global Configuration mode
User Guidelines
A default cost can be defined for an area, only after it has been defined. To define an area, use
the ospf area command.
242
OSPF Commands