Deny (Management) - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is
defined on the appropriate interface.The system supports up to 256 management access
rules.
Example
The following example shows how all ports are permitted in the access-list called "mlist".
Console (config)# management access-list mlist
Console (config-macl)# permit
deny (management)
The deny management access-list configuration command defines a deny rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel number | out-of-band-eth oob-
interface] [service service]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-
id | port-channel number | out-of-band-eth oob-interface] [service service]
•
ethernet interface-number—A valid Ethernet port number.
•
vlan vlan-id—A valid VLAN number.
•
port-channel number—A valid port-channel number.
•
ip-address—Source IP address.
•
mask mask—Specifies the network mask of the source IP address.
mask prefix-length—Specifies the number of bits that comprise the source IP address
•
prefix. The prefix length must be preceded by a forward slash (/).
•
service service—Indicates service type. Can be one of the following: telnet, ssh, http,
https or snmp.
•
out-of-band-eth oob-interface—Out-of-band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
209
Management ACL
Advertisement
Table of Contents
