Vlan Commands - Dell PowerConnect 6024F Command Line Interface Reference Manual

VLAN Commands

Command Group
vlan database
vlan
interface vlan
interface range vlan
name
switchport mode
switchport access vlan
switchport trunk allowed vlan
switchport trunk native vlan
switchport general allowed vlan
switchport general pvid
switchport general ingress-
filtering disable
switchport general acceptable-
frame-type tagged-only
switchport forbidden vlan
switchport protected
map protocol protocols-group
switchport general map
protocols-group vlan
show vlan
show vlan internal usage
show vlan protocols-groups
show interfaces switchport
46
Command Groups
Description
Enters the VLAN database configuration mode.
Creates a VLAN.
Enters the interface configuration (VLAN) mode.
Enters the interface configuration mode to configure multiple VLANs.
Configures a name to a VLAN.
Configures the VLAN membership mode of a port.
Configures the VLAN ID when the interface is in access mode.
Adds or removes VLANs from a port in general mode.
Defines the port as a member of the specified VLAN, and the VLAN
ID is the "port default VLAN ID (PVID)".
Adds or removes VLANs from a general port.
Configures the PVID when the interface is in general mode.
Disables port ingress filtering.
Discards untagged frames at ingress.
Forbids adding specific VLANs to a port.
Overrides the FDB decision and sends all Unicast, Multicast and
Broadcast traffic to an uplink port.
Adds a special protocol to a named group of protocols, which may be
used for protocol-based VLAN assignment.
Sets a protocol-based classification rule.
Displays VLAN information.
Displays a list of VLANs being used internally by the switch.
Displays protocols-groups information.
Displays switchport configuration.
Mode
GC
VC
GC
GC
VC
IC
IC
IC
IC
IC
IC
IC
IC
IC
IC
VC
IC
PE
PE
PE
PE