Show Ports Jumbo-Frame - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
Single Collision Frames
Late Collisions
Excessive Collisions
Internal MAC Tx Errors
Oversize Packets
Internal MAC Rx Errors
Received Pause Frames
Transmitted Pause Frames
show ports jumbo-frame
The show ports jumbo-frame user EXEC command displays the jumbo frames configuration.
show ports jumbo-frame
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the jumbo frames configuration.
Console# show ports jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset
146
Ethernet Configuration Commands
Counted frames that are involved in a single collision, and are
subsequently transmitted successfully.
Counted times that a collision is detected later than one slotTime into
the transmission of a packet.
Counted frames for which transmission fails due to excessive collisions.
Counted frames for which transmission fails due to an internal MAC
sublayer transmit error.
Counted frames received that exceed the maximum permitted frame
size.
Counted frames for which reception fails due to an internal MAC
sublayer receive error.
Counted MAC Control frames received with an opcode indicating the
PAUSE operation.
Counted MAC Control frames transmitted on this interface with an
opcode indicating the PAUSE operation.
Advertisement
Table of Contents
