Show Ip Dvmrp Prune - Dell PowerConnect 6024F Command Line Interface Reference Manual
Command
line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 6024F:
- User manual (474 pages) ,
- Getting started manual (66 pages) ,
- Getting started manual (154 pages)
Table of Contents
Advertisement
Example
The following example displays the DVMRP routing table contents.
Console# show ip dvmrp route
Source
------------- ---------------------- ------- -------- --------
171.68.0.0/16 192.168.1.28
The following table describes the fields shown in the display:
Field
Source
Neighbor
Interface
Metric
Expiry time
Up time
show ip dvmrp prune
The show ip dvmrp prune user EXEC command displays the Distance Vector Multicast Routing
Protocol (DVMRP) upstream prune state.
Syntax
show ip dvmrp prune [group group-address source-address | source-address]
•
group-address—Multicast group IP address
•
source-address—The source IP address
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
228
Multicast Routing Commands
Neighbor
Interface Metric
eth g1
Description
The network address that identifies the sources for which this entry contains
Multicast routing information.
The upstream neighbor (for example, RPF neighbor) address from which IP
datagrams from these sources are received.
The interface on which IP datagrams sent by these sources are received.
The distance in hops to the source subnet.
The minimum amount of time remaining before this entry is aged out.
The time since the route represented by this entry was learned by the router.
Expiry
Time
10
00:02:52 07:55:50
Up
Time
Advertisement
Table of Contents
