Snmpv3 Commands - Dell PowerConnect 6024F Command Line Interface Reference Manual

The default maximum number of times to resend an inform request is 3.
Command Mode
Global Configuration mode
User Guidelines
When configuring an SNMPv1 or SNMPv2 notification recipient, a notification view for that
recipient is automatically generated for all the MIB.
When configuring an SNMPv1 notification recipient, the Inform option cannot be selected.
If a trap and inform are defined on the same target, and an inform was sent, the trap is not
sent.
To define an SNMP recipient on the out-of-band port, use the out-of-band IP address format
oob/ip-address.
Example
The following example enables SNMP traps for host 10.1.1.1 with community string
"management" using SNMPv2.
Console (config)# snmp-server host 10.1.1.1 management 2

SNMPv3 Commands

snmp-server user
The snmp-server user global configuration command configures a new SNMP Version 3 user. To
delete a user, use the no form of this command.
Syntax
snmp-server user username groupname [remote engineid-string] [ auth-md5 password | auth-
sha password | auth-md5-key md5-des-keys | auth-sha-key sha-des-keys ]
no snmp-server user username [remote engineid-string]
• username—Specifies the name of the user on the host that connects to the agent. (Range:
1-30 characters)
• groupname—Specifies the name of the group to which the user belongs. (Range: 1-30
characters)
• engineid-string—Specifies the engine ID of the remote SNMP entity to which the user
belongs. The engine ID is a concatenated hexadecimal string. Each byte in the
hexadecimal character string is two hexadecimal digits. Each byte can be separated by a
period or colon. If the engine ID is not specified, the local engine ID is used. (Range: 5-32
characters)
363
SNMP Commands