Qos Map Udp-Port-Queue; Wrr-Queue Cos-Map - Dell PowerConnect 6024F Command Line Interface Reference Manual

Example
The following example shows how the mapped TCP ports 2000 and 80 are modified to queue 2.
Console (config)# qos map tcp-port-queue 2000 80 to 2

qos map udp-port-queue

The qos map udp-port-queue global configuration command modifies the UDP-Port to DSCP
table. To delete table entries, use the no form of this command. In the case where there are no
ports specified and the no form of this command is used, the complete table is deleted.
Syntax
qos map udp-port-queue port1...port8 to queue-id
no qos map udp-port-queue [port1...port8]
• port1...port8—Specify up to 8 ports (destination ports) separated by commas that are
being mapped. (Range: 1 - 65535)
• queue-id—Specify the queue number being mapped.
Default Configuration
The table is empty.
Command Mode
Global Configuration mode
User Guidelines
This command maps the UDP destination port in the ingress packet to a specified queue.
This map is used when the UDP trust mode is enabled and when the trust command is
enabled.
Example
The following example shows how the mapped UDP ports 2000 and 80 are modified to queue 2.
Console (config)# qos map udp-port-queue 2000 80 to 2

wrr-queue cos-map

The wrr-queue cos-map global configuration command maps assigned CoS values to select one of
the egress queues. To return to the default values, use the no form of this command.
Syntax
wrr-queue cos-map queue-id cos1...cosn
no wrr-queue cos-map [queue-id]
296
QoS Commands