Modifying A Virtual Port - Alcatel Omni Switch/Router User Manual

Modifying a Virtual Port

You can modify a virtual port through the
similar to the command and the port configuration phase of the
, enter the command, followed by the Group number for the port, and the physical slot
and port number for the port:
You can specify only one port at a time. For example, if you wanted to modify the parame-
ters for Port 7 on the module in Slot 4, and the Port currently resides in Group 6, then you
would enter:
The procedure for using
1. Enter followed by the Group number where the port currently resides, the physi-
cal slot and port number.
2. A prompt displays requesting your confirmation:
Simply press
ses (
Switch/Router. Virtual ports are numbered sequentially within the switch, not within a
Group or .
VLAN
3. The virtual port configuration menu displays:
Descriptions for each of the fields in this display begin on page 19-29. To change any
default value, enter the line number for the item, an equal sign (=), and then the value for
the parameter. When you have completed the configuration for this port, enter
save all configured settings.
is as follows:
if this is the correct virtual port. The Virtual Port number in parenthe-
in this case) is the virtual port number within this entire Omni
command. The command is very
Modifying a Virtual Port
command. To use
to
Page 19-45