The Switch Menu; Proprietary Ipx Token Ring; Factory Defaults - Alcatel Omni Switch/Router User Manual

The Switch Menu

The switch menu contains commands that allow you to set translation options discussed
earlier in this chapter. It also contains commands to change the default values.
To view the switch menu, enter
ing screen is displayed. Otherwise, type a
Menu:
The commands above and their operations are described in the sections below.

Proprietary IPX Token Ring

The propipx command allows you to turn on or off the default proprietary IPX switch transla-
tion. (Refer to Appendix B, "Output Translation Options," for information on the Proprietary
IPX feature.)
To turn on the Proprietary IPX feature (the default), enter the following at the system prompt:
A message is displayed to confirm the activation of the Proprietary IPX feature. Please note
that the switch must be rebooted for the setting to take effect.
To turn off the Proprietary IPX feature type:

Factory Defaults

You can reset all ports in the switch to their default factory settings. Any custom translations
you configured through
the default translation for the given media type (i.e., Ethernet, FDDI, etc.). Factory defaults for
each media type are described earlier in this chapter.
To reset to factory defaults, enter the
screen displays:
Enter a to reset all port settings.
at the prompt. If you are in verbose mode, the follow-
at the switch menu prompt to display the Switch
, , , , or
command at the system prompt. The following
The Switch Menu
commands will be overridden by
Page 18-25