Viewing An Isdn Configuration Entry - Alcatel Omni Switch/Router User Manual

Viewing an ISDN Configuration Entry

Viewing an ISDN Configuration Entry
The command is used to view the configuration of existing ISDN configuration entries.
You can either view a configuration summary for all ISDN ports on a specified slot, or display
the configuration for a single ISDN port.
To view configuration information on all ISDN ports on a specific slot, for example, slot 4,
enter the following command:
A screen similar to the following displays:
To view information on a specific ISDN port and slot, for example, slot 4, port 4, enter the
following command:
A screen similar to the following displays:
The fields on this screen are the same as those produced by the
Switch Type
Specifies the type of switch to which this ISDN port is to be connected. The options are:
AT&T 5ESS (
Euro-ISDN ETS 300/British Telecom NET3 (
B1/B2 Signalling Calling Address
The number assigned to this channel by the carrier. If only one address is supplied by the
carrier, it should be assigned to channel B1, and channel B2 should be left empty.
B1/B2 Service Profile Identifier (SPID)
The Service Profile Identifier assigned to this channel by the carrier. Normally, this value
contains the calling address surrounded by some digits. If only one address is supplied by the
carrier, it should be assigned to channel B1, and channel B2 should be left empty.
Page 32-6
), Northern Telecom DMS100 (
command:
), National ISDN-1 Bellcore (
).
), and