Table of Contents
Advertisement
NTP Statistics Menu
Display Event Timer Subsystem Statistics
The
switch. To view significant
screen similar to the following is displayed:
Field Descriptions
The following section describes the fields displayed using the
the
algorithm determines that an
NTP
uration, statistical, or timestamp.
Reset Various Subsystem Statistics Counters
To reset the counters displayed for the commands used in the
,
command at the system prompt followed by one or more of the following flags:
•
•
•
•
•
•
A brief message is displayed confirming the command.
Reset Stat Counters Associated With Particular Peer(s)
It is possible to remotely reset statistics for other
statistics for an
where
example, to reset statistics for a peer with
Page 12-28
command allows you to view significant
events, enter the
NTP
. The number of seconds since the last reset of
. The number of
alarms generated by this switch.
NTP
. The number of times the
. The number of requests from other
, and
), use the
association, enter the ntppreset command as follows:
NTP
is the either the domain name or
events that have occurred on this
NTP
command at the system prompt. A
entity is out of synchronization.
NTP
alarm routine was backed up.
NTP
entities for information, either config-
NTP
command. To reset the statistics, enter the
associations from the switch. To reset
NTP
address of the remote association. For
IP
address 1.1.1.4, enter:
IP
command.
.
NTP
alarms occur when
NTP
Statistics Menu (
NTP
,
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
