Using the TELNET Command
Using the TELNET Command
The
command is used to connect to another system. All of the standard
commands are supported by the software in the switch.
To initiate a
TELNET
A screen similar to the following displays:
To display a listing of the
A screen similar to the following displays:
Enter the desired commands to establish and conduct your
Cancelling a Telnet request
If you initiate a Telnet session to an IP address that is not responding, after several seconds
the switch will respond with the following message:
If you don't want to wait for the switch to timeout on its own, you can cancel your request
for a Telnet session by typing either
Page 25-30
session, enter the following command:
commands, enter the following command:
TELNET
or
session.
TELNET
.
TELNET