Next-Hop Addresses For Nbns - Alcatel Omni Switch/Router User Manual

NetBIOS Relays

Next-Hop Addresses for NBNS

At least one next-hop address (or a forwarding
NBNS Relay on page 26-15) must be configured.
To add a next-hop address for
1. On the UDP Relay Configuration screen command, enter the following:
A screen similar to the following displays:
2. Enter the
198.206.181.12), a hexadecimal address (i.e., 0xc6ceb501). A host name (i.e., system.com)
may be entered if the
3. Enter any additional addresses up to a maximum of 8. Press
Relay Configuration screen.
4. Enter to save the changes.
To delete next-hop addresses for the
1. Enter
FORWARD TO Server List displays.
2. Enter the item number that corresponds to the entry that you want to delete. Repeat this
step to delete any additional entries.
3. Press
4. Enter to save the changes.
Page 26-14
relay:
NBNS
address of the next hop. Enter the address in dotted decimal format (i.e.,
IP
resolver is enabled using the
DNS
This address may be the unicast address of the server
or a subnet broadcast address of the subnet where the
server is located. Using a unicast address is not recom-
mended because an
or all of its responsibility to another node in the
network segment.
NBNS
at the command prompt of the UDP Relay Configuration screen. The
to return to the UDP Relay Configuration screen.
as described in Forwarding VLANs for
VLAN
o Note o
by definition may shift part
NBNS
relay:
command.
to return to the UDP