Viewing Configurations For 10/100 Ethernet Modules - Alcatel Omni Switch/Router User Manual

Viewing Configurations for 10/100 Ethernet Modules

Viewing Configurations for 10/100 Ethernet Modules
The
Kodiak Ethernet Modules on page 15-3). These modules support 100 Mbps, or 1000 Mbps
Ethernet. Ethernet
the attached device.
Entering
The slot and port number (Intf) where this Ethernet port is located.
port will automatically sense whether the attached device operates at 10 Mbps or 100 Mbps
and adjust accordingly. If disabled, the port does not automatically detect the connection
speed and instead uses the line speed you configure through the
enable or disable auto-negotiation through
port does not support auto-sensing and the line speed defaults to either 10 or 100 Mbps.
The next set of columns are divided into
are the current operational
ured values; these configured values will either be defaults or the values configured through
.
Indicates the speed (in Mbps) at which the port is currently operating (
or configured to operate (
DETECTED
( ) in this column indicates the port is not connected to a device.
SET values will be
enabled and the Line Speed will equal the speed for which the attached device is config-
ured.
or full-duplex mode.
DETECTED
( ). A question mark ( ) in this column indicates the port is not connected to a device.
values will be auto-sensing (
SET
value is
setting. If this value is
value is
duplex mode through the
port for full-duplex if you disable auto-sensing.
Page 15-8
command allows you to view the current status of newer Ethernet modules (see
ports (e.g.,
10/100 ESX-K-100C-32
displays information similar to the following:
Indicates whether auto-negotiation is enabled on a 10/100 port. If enabled, the
).
SET
values will be (Mbps),
, (Mbps,) or
Indicates whether the port is operating (
values will be half-duplex (
, then the switch automatically sets the duplex mode to the network device's
, then the port will always run in half-duplex mode. If this
, then the port will always run in full-duplex mode. You configure the
) can auto-sense the connection speed of
. A value of
and . The columns under
DETECTED SET
or . The columns under SET are the config-
(Mbps), or a question mark ( ). A question mark
(Mbps). The
DETECTED
), full-duplex (
), half-duplex ( ), or full-duplex (full-d). If this
command. Note that you can only configure a
command. You
in this column means the
DETECTED
DETECTED
setting means auto-sensing is
) or configured ( ) for half-
SET
), or a question mark
10/100
)