Configuring A Wan Routing Service; Step 1. Set Up A Frame Relay Routing Group - Alcatel Omni Switch/Router User Manual

Alcatel switch/router release 4.5

Hide thumbs Also See for Omni Switch/Router:

Getting started manual (28 pages)

Table of Contents

Conﬁguring a WAN Routing Service

There are two main steps to configuring

1. Enable and configure routing for a specific

(Frame Relay Groups are different from other Groups as far as router configurations are

routing service through the

Both of these steps are described in the next two sections.

routing for a Group when you create the Group through the

The steps for setting up a Group are described in Chapter 24, "Managing Groups and Ports."

Please see that chapter for the generic steps used to create a Group. Also, understand the

following points where

• During the process of configuring the Group, the

following prompt:

If you want to configure

prompt. Otherwise, the Group will not be tagged correctly and will not be able to route

Frame Relay traffic.

• When configuring

Frame Relay routing always uses 1490 encapsulation.

• You do not set up physical interfaces (virtual ports) through the

cal mappings for Frame Relay are done through services, as described in Step 2 of this

You can configure all virtual circuits to automatically be assigned to the

you set up in this step. The

that you can set to a

ically be assigned to this Group without any configuration required. See Modifying a Port on

page 29-22 for more information on the

You can also configure a Frame Relay service using the

Set Up a Frame Relay Routing Service on page 29-60.

Groups differ from other Groups.

routing on this Group, then you must answer Yes to this

Routing, you do not specify a a default framing type since

command contains a parameter,

routing Group. All dynamically learned virtual circuits will automat-