The Search Command - Alcatel Omni Switch/Router User Manual

The Search Command

Starting from the page being displayed, the Search command ( ) searches all lines of a
for a specified text pattern (up to 80 characters). The first line containing the pattern is
brought to the top of the page, followed by any remaining lines in the table.
Searches cannot be limited to a specific column or heading.
To use the Search command, type at the
looking for, then press
The Search command is case sensitive. When using this
command, be sure to type the text pattern exactly as it
would appear in the
Real World Example
The following example uses the Search command to locate a specific
table. (Before using this example, be sure that the
default is set at 22 lines. For more information, refer to page 4-38.)
1. Type and press
Press again. A screen similar to the following will be displayed:
Type the slot number for the module containing the relevant
(e.g. ), then press
Note that, because the information in the table exceeds the
of 22 lines, the
UI Table Filtering (Using Search and Filter Commands)
.
o Important Note o
table.
UI
. The following screen will be displayed:
. A table similar to the following will be displayed:
prompt appears at the bottom of the screen.
prompt, followed by the text pattern you are
MAC
mode is enabled and the
address information
MAC
command's default page size
table
UI
address in the
Page 4-39