9 Configuring Switch-Wide
Parameters
The switch provides commands to display and configure parameters on a switch-wide basis.
These commands are grouped into two menus: the Summary menu and the System menu.
Descriptions for commands in the Summary menu begin below; descriptions for commands in
the System menu begin on page 9-5.
In addition, this chapter contains documentation for configuring
ports (described in
HRE-X
Configuring the HRE-X Router Port on page 9-27) duplicate
address support (described
MAC
in Duplicate MAC Address Support on page 9-30), multicast claiming (described in Multicast
Claiming on page 9-32), disabling flood limits (described in Disabling Flood Limits on page 9-
32), and saving configurations (described in Saving Configurations on page 9-33).
Summary Menu
The Summary menu consists of commands for displaying summary switch information. To
access this menu, enter
at the UI prompt. Type the question mark ( ) to see the following list of commands.
The Summary menu commands are described in the sections that follow.
Page 9-1