Ntp Administration Menu; Set The Primary Receive Timeout; Set The Delay Added To Encryption Time Stamps - Alcatel Omni Switch/Router User Manual

NTP Administration Menu

To view the Administration Menu, enter the
NTP
you are using verbose mode the
question mark ( ) at the prompt to display this menu:
The main menu options are shown in the
change menus.

Set the Primary Receive Timeout

The command allows you to specify the number of milliseconds the server waits for
a response to queries before the operation times out. The default is 8000 milliseconds. To
change the timeout, enter the ntptimeo command as shown:
where is the number of milliseconds of the new timeout length. For example, to set
the timeout value to 3000 milliseconds, enter the following:
To view the current timeout setting with out changing it, enter the
value. A message similar to the following is shown:

Set the Delay Added to Encryption Time Stamps

The command specifies a set time interval to add to timestamps included in server
requests that require authentication. This can be used to enable server configuration over long
delay network paths or between machines whose clocks are not synchronized.
To set the delay time, enter the ntpdelay command as shown:
where is the number of milliseconds of the new delay time length. For example, to
set the delay value to 30 milliseconds, enter the following:
To view the current delay setting with out changing it, enter the
value. A message similar to the following is shown:
command at the system prompt. If
configuration menu is displayed. Otherwise, enter a
NTP
list for quick access if you need to
NTP Administration Menu
command with no
command with no
Page 12-33