If You Chose Dump To Screen; If You Did Not Choose Dump To Screen - Alcatel Omni Switch/Router User Manual

Port Monitoring

If You Chose Dump to Screen

If you selected the
your terminal screen. The following shows an example of this data
Each line in the display represents a packet. The destination MAC address, source MAC
address, protocol type and actual packet data are shown. The amount of data shown is
configured through the
packet. You can stop the data dump to the screen at anytime by pressing
also pause the data dump by pressing

If You Did Not Choose Dump to Screen

If you did not select the
monitoring occurs in the background. You can continue using other UI commands. The port
monitoring session data is saved in the file you indicated through the
monitor the session at anytime by using the
in-progress session using the
sections describes
Ending a Port Monitoring Session (pmdelete)
The
but not being dumped to the console screen. To end the session, enter:
A message similar to the following displays:
If a port monitoring session was not in progress then the following message displays:
Pausing a Port Monitoring Session (pmpause)
The
file but not being dumped to the console screen. To pause the session, enter:
The following message displays
To resume the port monitoring session, enter
If a port monitoring session was not in progress, then the following message would display:
Page 19-64
option, then a real-time synopsis of the session displays on
command. The above sample shows 16 bytes of data per
and
command ends a port monitoring data capture session that is being saved to file
command pauses a port monitoring data capture session that is being saved to
to pause.
option, then the system prompt will return and port
command. You can also end or pause an
or commands, respectively. The following
.
again. The following message displays:
to quit. You can
screen. You can